Makita TW005G Manuel d'instruction - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita TW005G. Makita TW005G 16 pages. Cordless impact wrench
Également pour Makita TW005G : Manuel d'instruction (17 pages)

Imprimer la page

Tool with the detent pin

For TW005G

Fig.12

► 1 . Impact socket 2. Hole 3. Square drive 4. Detent pin

Align the hole in the side of the impact socket with the detent

pin on the square drive and push the impact socket onto the

square drive until it locks into place. Tap it lightly if required.

To remove the impact socket, simply pull it off. If it is

hard to remove, depress the detent pin while pulling the

impact socket.

Installing hook

WARNING:

Use the hanging/mounting parts

for their intended purposes only, e.g., hanging the

tool on a tool belt between jobs or work intervals.

WARNING:

Be careful not to overload the

hook as too much force or irregular overburden

may cause damages to the tool resulting in per-

sonal injury.

CAUTION:

When installing the hook, always

secure it with the screw firmly. If not, the hook may

come off from the tool and result in the personal injury.

CAUTION:

Make sure to hang the tool securely

before releasing your hold. Insufficient or unbalanced

hooking may cause falling off and you may be injured.

Fig.13

► 1 . Groove 2. Hook 3. Screw

The hook is convenient for temporarily hanging the tool.

This can be installed on either side of the tool. To install

the hook, insert it into a groove in the tool housing on

either side and then secure it with a screw. To remove,

loosen the screw and then take it out.

13 ENGLISH

Using hole

WARNING:

Never use the hanging hole for

unintended purpose, for instance, tethering the

tool at high location. Bearing stress in a heavily

loaded hole may cause damages to the hole, result-

ing in injuries to you or people around or below you.

Fig.14

► 1 . Hanging hole

Use the hanging hole at the bottom rear of the tool to

hang the tool on a wall using a hanging cord or similar

strings.

OPERATION

CAUTION:

Always insert the battery cartridge

all the way until it locks in place. If you can see the

red indicator on the upper side of the button, it is not

locked completely. Insert it fully until the red indicator

cannot be seen. If not, it may accidentally fall out of

the tool, causing injury to you or someone around

you.

Fig.15

Hold the tool firmly and place the impact socket over

the bolt or nut. Turn the tool on and fasten for the proper

fastening time.

The proper fastening torque may differ depending upon

the kind or size of the bolt, the material of the workpiece

to be fastened, etc. The relation between fastening

torque and fastening time is shown in the figures.