Gardena PowerCut Li-40/30 Manuel de l'opérateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Gardena PowerCut Li-40/30. Gardena PowerCut Li-40/30 19 pages. Battery trimmer
Également pour Gardena PowerCut Li-40/30 : Manuel de l'opérateur (12 pages)
Imprimer la page
To replace the filament
cassette:
u
o
o
a
5. STORAGE
To put into storage:
Disposal:
(in accordance with
RL2012/19/EC)
22
DANGER! Risk of injury!
Risk of injury from metal cutting parts!
v Do not use metal cutting parts or replacement parts and
i
accessories not approved by GARDENA.
v Only use original GARDENA Filament Cassettes.
You can order the Replacement Filament Cassettes from your
GARDENA dealer or directly from the GARDENA Customer Service.
For Art. 9827 PowerCut Li 40/30:
GARDENA Filament Cassette for Trimmers Art. 5307
p
1. Push in cassette cover
time and remove it.
2. Remove the filament cassette
3. Remove all possible dirt of the filament cassette holder
4. Pull approx. 15 cm of the cutting filament
filament cassette
d
5. Put the cutting filament
r
6. Put the cutting filament
s
7. Put the filament cassette
8. Attach the cassette cover
until both locking clips audibly engage.
Make sure that the cutting filament is not squeezed.
If the cassette cover
o
p
sette
back and forth, until the filament cassette
the filament cassette holder
The product must be stored away from children.
1. Remove the battery.
2. Charge the battery.
3. Clean the trimmer, the battery and the battery charger
(see 4. MAINTENANCE).
4. Store the trimmer, the battery and the battery charger in a dry,
enclosed and frost-free place.
The product must not be disposed of to normal household waste.
It must be disposed of in line with local environmental regulations.
IMPORTANT!
Dispose of the product through or via your municipal recycling
collection centre.
u
on the two locking clips
o
.
o
through the hole in the plastic ring
r
through the metal sleeve
r
around the guide pin
o
into the filament cassette holder
u
on the filament cassette holder
u
cannot be attached, turn the filament cas-
p
.
i
at the same
p
.
r
out of the new
a
.
s
.
d
.
p
.
p
o
is completly in