Gardena SmallCut Plus 350/23 Manuel d'utilisation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Gardena SmallCut Plus 350/23. Gardena SmallCut Plus 350/23 15 pages. Turbotrimmer
Également pour Gardena SmallCut Plus 350/23 : Manuel de l'opérateur (9 pages), Manuel de l'opérateur (6 pages)
Imprimer la page
5. STORAGE
To put into storage:
Disposal:
(in accordance with
RL2012/19/EC)
6. TROUBLESHOOTING
To pull the cutting filament
out of the filament cassette:
t
z
t
5
z
8
The unit must be stowed away from children.
1. Disconnect the mains cable.
2. Clean the unit (see 4. MAINTENANCE).
3. Stowe the unit in a dry area where it has protection from frost.
Recommendation:
The unit can be hung up by the handle. The cutting head is not put
under too much strain if the unit is stowed hanging up.
The unit must not be added to usual household waste.
Refer to local environmental laws for discarding.
v I mportant: Make sure that the unit is discarded through your
municipal recycling collection centre.
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v Before you troubleshoot the unit, make sure that the
mains cable is disconnected.
If a cutting filament is pulled into the filament cassette you can pull it
out again with the instructions below.
1. Remove the filament cassette
4. MAINENANCE "To replace the filament cassette".
2. Push together the plastic ring
between your thumb and index finger.
3. Pull the plastic ring
z
(if necessary, use a screwdriver).
4. You can at this time get the cutting filament that was pulled into
the filament cassette.
5. Unwind the cutting filament
the eye of the plastic ring
cutting filament beforehand using a screwdriver, and unwind and
wind fully).
6. Pull the plastic ring
z
7. Install the filament cassette
4. MAINTENANCE "To replace the filament cassette".
with the instructions under
t
on the filament cassette
z
over the side part of the filament cassette
by approx. 15 cm and put it through
5
(if necessary, loosen the welded
z
onto the filament cassette
with the instructions under
t
t
.
t