KitchenAid GCI3061XB00 Manuel d'instructions d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid GCI3061XB00. KitchenAid GCI3061XB00 16 pages. 27" (68.6 cm) and 30" (76.2 cm) electric built-in convection microwave oven

Imprimer la page

Excessive Weight Hazard

Use two or more people to move and install

microwave oven.

Failure to do so can result in back or other injury.

1. Using 2 or more people, lift the microwave oven partially into

the cabinet cutout above the spacer bars. Place the

microwave oven on top of the spacer bars and to the outside

of the guide flanges.

NOTE: Open the microwave oven door and push against the

seal area of the microwave oven front frame when pushing

the microwave oven into the cabinet. Do not push against the

outside edges.

2. Push against the front frame of the microwave oven to push

the oven into the cabinet. Push the microwave oven

completely into the cabinet and center in the cabinet cutout.

A. Guide flange

B. Spacer bar

C. Microwave

oven

3. Using a 1/8"(3.2 mm) drill bit, predrill pilot holes into the

cabinet through the holes in the mounting rails on each side

of the microwave oven.

4. Securely fasten microwave oven to cabinet using the 2

screws provided. Insert the screws through holes in mounting

rails. Do not overtighten screws.

5. Reattach the bottom vent that was removed in the "Install

Spacer Kit" section.

6. Replace oven racks, turntable and support hub.

7. Reconnect power.

8. Display panel will light briefly, and "PF" should appear in the

display.

9. If display panel does not light, please reference the

"Assistance

or Service" section of the Use and Care Guide or

contact the dealer from whom you purchased your

microwave oven.

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. For microwave oven use and cleaning, read the Use and Care

Guide.

Check Operation

of Microwave

Oven

1. Turn power on.

2. When "CLOCK ENTER TIME" appears in the display, press

START/ADD A MINUTE.

3. Fill a microwave-safe

container with 1 cup (250 mL) of water

and place container inside microwave oven on the turntable.

Close door firmly.

4. Touch START/ADD A MINUTE twice to set cooking time to

"2:00" minutes. Microwave should begin cooking, interior

light should be on, and the display should count down the

remaining time.

If microwave

does not operate,

check the following:

•

Household fuse is intact and tight; or circuit breaker has

not tripped.

•

Electrical supply is connected;

•

See "Troubleshooting"

section in the Use and Care Guide.

•

If an error code ("F" followed by a number plus "E"

followed by a number) appears in the display, turn off the

microwave oven and contact a qualified technician.

When the display reads "1:00" minute, open the microwave

oven door. The microwave should stop cooking. Close door

firmly. The interior microwave oven light should turn off.

5. Press START/ADD A MINUTE to resume preset cycle.

Microwave should begin cooking, and the microwave oven

interior light should be on.

Let microwave oven complete cooking time. A tone will

sound 3 times at the end of the cooking time.

6. Open microwave oven door and slowly remove container.

Water in container should be hot.

If you need Assistance

or Service:

Please reference the "Assistance or Service" section of the

Use and Care Guide or contact the dealer from whom you

purchased your built-in microwave oven.

A. Two screws