Avaya 200-Type Module Analog Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avaya 200-Type Module Analog. Avaya 200-Type Module Analog 5 pages. 20-type stand, 200-type module analog (u.s.) adjunct interface, and 201-type module recorder interface
Également pour Avaya 200-Type Module Analog : Instructions d'installation et de sécurité (12 pages)
Imprimer la page
Problems Related to External Speakerphones
The following problems may occur with some external speakerphones connected to the 200-type module. These
problems may occur with other equipment as well.
PROBLEM: YOU CANNOT MAKE/ANSWER CALLS AT YOUR 2420 TELEPHONE
The analog equipment attached to your 2420 telephone may be off-hook because it does not detect the
"disconnect" signal sent from the 200-type module. You must manually turn off (that is, place on-hook) your analog
equipment.
PROBLEM: ANALOG EQUIPMENT DOES NOT GO ON-HOOK WHEN YOU LIFT TELEPHONE HANDSET
The analog equipment attached to your 2420 telephone may not go on-hook automatically when you lift the 2420
telephone handset for two reasons. First, make sure that the switch settings on the 200-type module are correct.
Remove power and refer to the 20-Type Stand, 200-Type Module Analog (U.S.) Adjunct Interface, and 201-Type
Module Recorder Interface Installation and Safety Instructions (555-233-132). If the settings are correct, the analog
equipment does not detect the "disconnect" signal sent from the 200-type module. You must manually turn off (that
is, place on-hook) your analog equipment.
PROBLEM: ANALOG EQUIPMENT DOES NOT GO ON-HOOK WHEN THE FAR END DISCONNECTS
The analog equipment attached to your 2420 telephone may not go on-hook automatically when the far end of a
call disconnects because the equipment does not detect the "disconnect" signal sent from the 200-type module.
You must manually turn off (that is, place on-hook) your analog equipment.
3