4. MAINTENANCE
DANGER! Risk of injury!
Cut injury when the product starts
accidentally.
v Before you maintain the product, make sure that
the protective cover
[ Fig. I1 ].
To clean the Grass Shear [ Fig. I1 ]:
DANGER! Electric shock!
Risk of injury and risk of damage to property.
5. STORAGE
To put into storage [ Fig. I1 ]:
The product must be stored away from children.
1. Charge the battery. This increases the life of the battery.
2. Clean the product (see 4. MAINTENANCE) and slide
1
the protective cover
over the blade
3. Store the product in a dry area where it has protection
from frost.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal
household waste. It must be disposed of in line with local
environmental regulations.
6. TROUBLESHOOTING
DANGER! Risk of injury!
Cut injury when the product starts
accidentally.
v Before you troubleshoot the product, make
sure that the protective cover
blade
2
[ Fig. I1 ].
To change the blade [ Fig. T1 ]:
Only an original GARDENA blade is allowed to be
used. A new blade can be ordered by the GARDENA
Service.
Problem
The jack flashes red
while charging
Runtime too low
The product does not
cut cleanly
1
2
is slid over the blade
2
.
1
is slid over the
Possible Cause
Allowed battery temperature
was exceeded.
Blade soiled.
Blade blunt or damaged.
v Do not clean the product with water or with
a water jet (in particular high-pressure water jet).
To increase operating time, the product should be cleaned
and sprayed after each use.
1. Clean the product with a damp cloth.
2
2. Lubricate the blade
with a low viscosity oil
(e. g. GARDENA spray-oil Art. 2366). Avoid contact
with the plastic parts.
IMPORTANT!
Dispose of the product through or via your municipal
recycling collection centre.
Disposal of the battery [ Fig. S1 ]:
The GARDENA battery contains lithium-ion cells that
should not be disposed of with normal household waste
at the end of its life.
IMPORTANT!
Dispose of the batteries through or via your municipal
recycling collection centre.
1. Discharge lithium-ion cells
2. Remove lithium-ion cells
3. Dispose of lithium-ion cells
(9)
1. Pull the flap
upwards and slide the lid
2
2. Remove the blade
.
3. If necessary clean the transmission chamber and lubri-
cate the excentric drive
(Vaseline).
4. Turn the excentric drive
w
5. Pull the crank
on the back side of the blade
middle.
2
6. Place the new blade
q
that the excentric drive
7. Slide the lid
(10)
upwards until it makes a click.
Remedy
v Let the battery cool down. Restart
the charging.
v Clean and lubricate scissor blade in
accordance with the maintenance
instructions.
v Change the blade
(see To change the blade).
8
completely.
8
from the product.
8
properly.
(10)
downwards.
q
with some acid-free grease
q
downwards.
2
in the
on the motor unit in such a way
w
is inserted in the crank
.
13
Imprimer la page