Avaya B100 Series Manuel de configuration
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Avaya B100 Series. Avaya B100 Series 2 pages. Configuring b100 series phones on ip office
Imprimer la page
Introduction
The B100 Series of phones are a range of high-quality audio conference phones. The IP Office platform supports the
B149 (analog), B159 (analog) and B179 (SIP) models. The following are the key steps to enable correct operation on IP
Office systems:
1. Set the region
2. Set the flash hook time (B149/B159 phones only)
3. Set the caller ID method (B149/B159 phone only)
4. Set the conference codes
Full SIP phone installation of the B179 is covered in the "Installing and Administering the IP Office B179 SIP Conference
Phone" manual.
Set the Region
To set the region:
1. Press the
Menu button.
2. Scroll to SETTINGS and press OK.
3. Scroll to REGION and press OK.
4. Scroll to the region required and press OK.
5. To exit the menus, press
Set the Flash Hook Time
The B149 and B159 analog phones need to use a flash hook time in the same range as that being used by the IP Office.
That default values the IP Office uses depend on its system locale, refer to the "IP Office Locale Settings Reference"
manual. However, individual extensions can be configured separately (see Extension | Analogue | Flash Hook Pulse
Width). The setting can be tested by making a call to another extension during which pressing
on hold and back if the flash hook time is set correctly.
To set the flash hook time:
1. Press the
Menu button.
2. Scroll to SETTINGS and press OK.
3. Scroll to FLASH and press OK.
4. Select a value that falls in the range set in the IP Office configuration for the extension and press OK.
5. To exit the menus, press
Set the Caller ID Type
B149/B159 phones need to be set to use the same caller ID method as the IP Office system (System | Telephony |
Tones & Music | CLI Type).
To set the caller ID type:
1. Press the
Menu button.
2. Scroll to SETTINGS and press OK.
3. Scroll to CALLER ID and press OK.
4. Select the method that matches the IP Office system and press OK.
5. To exit the menus, press
Job Aids
IP Office
Configuring B100 Series
Phones on IP Office
Menu again. To exit the current menu option, press
Menu again. To exit the current menu option, press
Menu again. To exit the current menu option, press
.
should toggle the call
.
.
03a (22/09/2017)
Page 1