Gardena SILENO+ Manuel rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Gardena SILENO+. Gardena SILENO+ 4 pages.
Également pour Gardena SILENO+ : Démarrage rapide (4 pages), Manuel rapide (4 pages)

Imprimer la page

3. To connect the boundary wire

1. Open the connector and lay the boundary wire in the connector.

2. Press the connector and the wire together by using a pair of pliers.

3. Cut off the wire 1-2 cm / 0.4-0.8 in. after the connectors.

4. Press the boundary wire connectors onto the contact pins marked L (left) and R (right)

on the charging station.

NOTE: The right-hand wire must be connected to the right-hand contact pin on the

charging station, and the left-hand wire to the left-hand pin.

4. To install and connect the guide wire

Install a guide wire to lead the robotic lawn mower to remote parts of the lawn and

to help it to find the charging station.

1. Push the guide wire through the bottom of the charging station and fasten it into

place using the snap locks.

2. Fit the connector to the guide wire in the same way as for the boundary wire,

according to the instructions above.

3. Press the guide wire connector onto the contact pin marked GUIDE on the

charging station.

4. Pull the guide wire a minimum of 2 m / 7 ft. straight out from the front edge of the

charging station.

5. Lay the guide wire from the charging station to the point on the boundary wire

(eyelet) where the connection is made using stakes supplied or bury the wire.

NOTE: Do not lay the guide wire in sharp bends and it cannot cross the boundary

wire that for instance is laid out for an island.

6. Cut the boundary wire at the center of the eyelet that was made in step 2.3.

7. Connect the guide wire to the boundary wire by inserting the boundary wires and

guide wire in the coupler, and pressing the coupler together with a pair of pliers.

NOTE: After the guide wire is installed. Attach the charging station to the ground

with the supplied screws and allen key.

NOTE: For optimal performance through narrow passages please ensure the gui-

de wire is laid correctly through it. Please read the Operator's manual for further

instructions.

Power supply

(the appearance of the power supply

may differ depending on market)

QG_P15_Gardena_EN_1141856-26_20191015.indd 3

Low voltage cable

Boundary wire and

couplers

Stakes

Connectors

min 2 m / 7 ft

Measurement

gauge

2019-10-17 11:00:52