Makita 6013BR Manuel d'instruction - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 6013BR. Makita 6013BR 8 pages. Makita 6013br drill:
Également pour Makita 6013BR : Manuel d'instruction (8 pages), Liste des pièces (6 pages), Manuel d'instruction (20 pages)

Imprimer la page

For Model 6013BR

003011

The switch is reversible, providing either clockwise or

counterclockwise rotation. To start the tool, simply pull

the lower part of the switch trigger for clockwise or the

upper part for counterclockwise. Release the switch

trigger to stop.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before carrying out any work on the

tool.

Installing top grip (auxiliary handle)

003035

Screw the top grip on the tool securely.

Installing or removing drill bit

For tool with standard keyed chuck

003046

To install the bit, place it in the chuck as far as it will go.

Tighten the chuck by hand. Place the chuck key in each

of the three holes and tighten clockwise. Be sure to

tighten all three chuck holes evenly.

1. Counterclockwise

2. Switch trigger

3. Clockwise

1. Chuck key

To remove the bit, turn the chuck key counterclockwise

in just one hole, then loosen the chuck by hand.

After using the chuck key, be sure to return to the

original position.

For tool with keyless chuck

004644

Hold the ring and turn the sleeve counterclockwise to

open the chuck jaws. Place the bit in the chuck as far as

it will go. Hold the ring firmly and turn the sleeve

clockwise to tighten the chuck.

To remove the bit, hold the ring and turn the sleeve

counterclockwise.

OPERATION

Drilling operation

Always use the top or back grip (auxiliary handle) and

firmly hold the tool by top or back grip and switch handle

during operations.

010321

Drilling in wood

When drilling in wood, the best results are obtained with

wood drills equipped with a guide screw. The guide

screw makes drilling easier by pulling the bit into the

workpiece.

Drilling in metal

To prevent the bit from slipping when starting a hole,

make an indentation with a center-punch and hammer at

the point to be drilled. Place the point of the bit in the

indentation and start drilling.

Use a cutting lubricant when drilling metals. The

exceptions are iron and brass which should be drilled

dry.

1. Tighten

2. Sleeve

3. Ring