Makita 601DST Manuel d'instruction - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 601DST. Makita 601DST 15 pages. 10 mm (3/8") battery-powered driver dril
Imprimer la page
Installing or removing
the
drill bit
CAUTION :
Always be sure that the tool i s switched off and the batterv is disconnected from the tool
before installing or removing the bit.
To install the bit, place
it in the chuck
as
far
as it
will go. Tighten the chuck by hand.
Place the chuck key in each of the three
holes and tighten clockwise. Be
sure
to
tighten
a l l
three chuck holes evenly.
To remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
After using the chuck key, be sure to return
it
to the original position
Switch action
To start the tool, simply pull the trigger. Tool speed i s increased by increasing pressure on
the trigger. Release the trigger to stop.
CAUTION :
Before connecting the battery to the tool, always check to
see
that the switch trigger
actuates properly and returns to the "OFF" position when released.
Reversing switch action
This tool has a reversing switch to change
the direction of rotation. Move the revers-
ing switch lever to the right for clockwise
rotation or to the left for counterclockwise
rotation.
Aeversing switch lever
/
CAUTION :
Always check the direction of rotation before operation.
*The reversing switch lever cannot be moved while the trigger i s pulled.
Use the reversing switch only after the tool comes to complete stop. Changing the
direction of rotation before the tool stops may damage the tool.
9