Makita 6096D Manuel d'instruction - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 6096D. Makita 6096D 17 pages. Cordless high speed drill equipped with electric brake
Également pour Makita 6096D : Manuel de l'utilisateur (5 pages), Manuel d'instruction (9 pages), Manuel d'instruction (13 pages)
Imprimer la page
3
1. Sleeve
2. Ring
3. Tighten
2
1
1. Depth gauge
2. Washer
3. Clamp screw
OPERATION
10
Installing or removing driver bit or drill bit
002120
Hold the ring and turn the sleeve counterclockwise to open
1
the chuck jaws. Place the bit in the chuck as far as it will go.
2
Hold the ring firmly and turn the sleeve clockwise to tighten
the chuck.
To remove the bit, hold the ring and turn the sleeve counter-
clockwise.
Depth gauge
002126
The depth gauge is used to drill holes of uniform depth.
Install the depth gauge on the tool with the clamp screw and
washer. Adjust the depth gauge to the desired depth and
tighten the clamp screw.
3
Drilling operation
Drilling in wood
When drilling in wood, the best results are obtained with
wood drills equipped with a guide screw. The guide screw
makes drilling easier by pulling the bit into the workpiece.
Drilling in metal
To prevent the bit from slipping when starting a hole, make
an indentation with a center-punch and hammer at the point
to be drilled. Place the point of the bit in the indentation and
start drilling.
Use a cutting lubricant when drilling metals. The exceptions
are iron and brass which should be drilled dry.
CAUTION:
•
Pressing excessively on the tool will not speed up the
drilling. In fact, this excessive pressure will only serve to
damage the tip of your bit, decrease the tool
performance and shorten the service life of the tool.
•
There is a tremendous force exerted on the tool/bit at the
time of hole break through. Hold the tool firmly and exert
care when the bit begins to break through the workpiece.