Makita 6170D Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 6170D. Makita 6170D 12 pages. 10 mm (3/8”) cordless driver dril
Imprimer la page
Charging
Uncao the connector hole.
Connect the charging plug to the charging
connector, then plug in the charger to the
CAUTION
:
The battery in your new tool is not fully charged. You will need to charge
it
before use.
Do not operate the tool during charging.
Overcharging more than 2 days considerably shortens the battery service life. Always
unplug the charger after completing the charge. Then cap the charging connector hole.
When you charge
a
new tool or
a
tool which has not been used for
a
long period, it may
not accept a full charge. This i s a normal condition and does not indicate a problem.
You can recharge the tool fully after discharging it almost completely
a
couple of times.
Installing or removing drill bit or driver bit
Always
set
the reversing switch lever to the neutral position before installing or removing
the bit.
To install the bit, place
it
in the chuck
as
far as it will go. Tighten the chuck by
hand. Place the chuck key in each of the
three holes and tighten clockwise.
Be sure to tighten all three chuck holes
evenly.
To remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
6