Makita 6236DWBE Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 6236DWBE. Makita 6236DWBE 20 pages. Cordless driver drill equipped with electric brake
Également pour Makita 6236DWBE : Manuel d'instruction (20 pages)

Imprimer la page

*When driving wood screws, predrill pilot

Nominal diameter

holes to make driving easier and to pre-

wood

("I

vent splitting of the workpiece. See the

chart.

3.1

11/8"1

3.8 (5/32"1

3,5 (9164,,1

4.5

(11/64"1

4.8 13/16")

5.1 (1 3/64"]

5 5 17/32"]

3 7

3 9 (9/64"

5/32',)

5 8 17/32',)

4 2

15/32"

11/64")

Recommended

size

of pilot hole Imml

2.0

2.2

15/64"

3/32")

2.2

2.5 (3/32"

3/32',)

2.5

2.8 13/32"

7/64',)

2.9

- -

3.2

(7/64"

1/8"1

3.1

3.4

(1/8"

9 / 6 4 ' ]

3.3

3.6 11/8"

9/64"]

6.1

5/64")

4.2

4.4 (11164''

- .

11/64"]

*If the tool is operated continuously until the battery cartridge has discharged, allow the

tool

to rest for 15 minutes before proceeding with a fresh battery.

Drilling operation

First, turn the adjusting ring so that the pointer on the tool body points to the

marking.

Then proceed as follows.

*Drilling in wood

When drilling in wood, best results are obtained with wood drills equipped with a guide

screw. The guide screw makes drilling easier by pulling the bit into the workpiece.

To prevent the bit from slipping when starting a hole, make an indentation with a center-

punch and hammer at the point to be drilled. Place the point of the bit in the indentation

and start drilling.

Use a cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

*Drilling in metal

CAUTION:

*Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pres-

sure will only serve to damage the tip of your bit, decrease the tool performance and

shorten the service life of the tool.

*There is a tremendous force exerted on the tool/bit at the time of hole breakthrough.

Hold the tool firmly and exert care when the bit begins to break through the workpiece.

*A stuck bit can be removed simply by setting the reversing switch to reverse rotation in

order to back out. However, the tool may back out abruptly if you do not hold it firmly.

*Always secure small workpieces in a vise or similar hold-down device.

*If the tool is operated continuously until the battery cartridge has discharged, allow the

tool to rest for 15 minutes before proceeding with a fresh battery.