Makita 6302 Manuel d'instruction - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 6302. Makita 6302 8 pages. 13 mm (1/2”) variable speed/reversing
Également pour Makita 6302 : Manuel d'instruction (8 pages), Manuel d'instruction (8 pages)
Imprimer la page
ADDITIONAL SAFETY RULES
1.
Always be sure you have a firm footing.
2.
Hold the tool firmly.
3.
Keep hands away from rotating parts.
4. When drilling into walls, floors or wherever "live" electrical wires may be
encountered,
DO
NOT TOUCH ANY METAL PARTS
OF
THE
TOOL!
Hold the tool by the insulated grasping surfaces t o prevent electric shock
if
you drill into a "live" wire.
Be sure no one is below when using the tool in high locations.
5. Do
not leave the tool running. Operate the tool only when hand-held.
6. Do
not touch the drill bit or the workpiece immediately after operation; they
may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
Installing side
grip
(auxiliary handle)
Screw the side grip on the tool securely.
Installing or removing drill bit
CAUTION :
Always be sure that the tool is switched off and unplugged before installing or removing
the bit.
To install the bit, place it in the chuck as
far as
it
will go. Tighten the chuck by hand.
Place the chuck key in each of the three
holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
Chuck
key
4