Align Trex SE Manuel de configuration - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Align Trex SE. Align Trex SE 14 pages. Helicopter

Align Trex Se Setup Guide

Ch. 2 is mounted from the inside of the right frame.

Servo Centering and Direction can now be checked.

Remove all servo arms from the servos.

Set Aileron D/R Switch to 1.

Turn on the transmitter.

Make sure all of your trims are at 0.

Set your collective (left stick) to center. It should be in the same position as the right stick.

Disconnect your motor from the Electronic Speed Control (ESC) and plug a fully charged battery

pack into the ESC. Leave the helicopter stationary until the Gyro initiates.

Begin putting the servo arms on each of the servos, lining the arm up as close to center as possible.

See Figure A, B and C above for arm orientation. It is not necessary to hook up the linkage at this

time. Do not worry if they do not line up exactly. We will make adjustments later by using subtrim. If

you find a control horn is very far off from center try a different control horn.

Now we can check servo direction.

If any servo reversing was necessary, you may have to check for servo arm alignment again to make

sure they are as close to center as possible.

We will now adjust the subtrim to center any servo arms that need centering.

http://www.digimemphoto.com/pdf/ (4 of 13)1/25/2006 7:09:05 PM

Move your right stick (cyclic) to the right. Channel 2 servo arm should move down and

Channel 6 servo arm should move up.

If this is not the case you will need to reverse one or both of the servos depending

on what reaction occurred.

Move the right stick (cyclic) forward. The Channel 3 servo arm should move up while the

Channel 6 and 2 servo arms move down. The opposite applies when the right stick is pulled

back.

If this is not the case you will need reverse the Channel 3 servo.

Move the left stick (rudder) to the left. The Ch. 4 servo arm should move towards the tail of

the heli.

If this is not the case then you will need to reverse this servo.

Move the left stick (throttle) up and down. Ch 2, 3 and 6 should move together in direction

relation to the stick movement.

Turn the transmitter on if it is not already on.

Make sure both sticks are in the center position.

Push scroll and Increase at the same time to enter Function Mode.

Press scroll until you reach the SB-TRIM Menu.

Figure C