Garmin VIB 11 - GPS Receiver Manuel d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Garmin VIB 11 - GPS Receiver. Garmin VIB 11 - GPS Receiver 2 pages. Garmin gps receiver user manual
Imprimer la page
Warning
Failure to avoid the following potentially hazardous situations could result in an accident
or collision resulting in death or serious injury.
•
Do not open the VIB or loosen the case screws. Doing so will void the warranty.
•
When extending ignition, battery, or ground wires, use automotive-grade wires or other wires
with AWG 18 (0.75 mm2) gauge or greater.
•
Connect the ignition wires to a power source that can be turned on and off with the ignition
key. If you connect the ignition wire to a power source with a constant voltage supply, such as
battery wires, the vehicle's battery may die.
notE: There may be additional signals from the
stereo that are not shown on this diagram. Any such
signals should be connected directly back to the
stereo.
VIB 10/11 24-Pin
Connector
2
1
VIB 10/11 Connectors
Video In
To PND
(GPS navigator)
Ant Out
to stereo's
antenna
connector
(VIB 11 Only)
Ant In from vehicle's antenna
(VIB 11 Only)
VIB 11 Antenna Connections
Stereo's antenna
connector
24
Output Level
23
To Stereo/
vehicle wiring
(24-pin
connector)
Audio Out
(optional)
To Stereo Adapter Cable
adapter to
Fakra to VIB 11
stereo
Ant. Out
•
Make sure to ground the VIB to the chassis of the vehicle.
•
Secure all wiring with cable clamps or electrical tape. Insulate unconnected wires; do not
allow any bare wiring to remain exposed.
•
Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can
conduct electricity.
•
Do not expose the unit to water or other liquids. The unit is not waterproof.
•
Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity,
or dust.
VIB 10/11 Wiring Diagram
Pink
Reverse In
1
Light Green
Mute Out
2
Black
Ground In
3
Black
Ground In
4
Yellow
12 VDC In
5
Yellow
12 VDC In
6
Red
Ignition
7
Tan
8
Green/Black
LR (-) Out
9
Green
LR (+) Out 10
Purple/Black
RR (-) Out 11
Purple
RR (+) Out 12
White/Black
LF (-) Out 13
White
LF (+) Out 14
Grey/Black
RF (-) Out 15
Grey
RF (+) Out 16
Green/Black
LR (-) In 17
Green
LR (+) In 18
Purple/Black
RR (-) In 19
Purple
RR (+) In 20
White/Black
LF (-) In 21
White
LF (+) In 22
Grey/Black
RF (-) In 23
Grey
RF (+) In 24
To Antenna Adapter Cable
Fakra to VIB 11
Ant. In
Stereo
Optional
Optional
Ground for Low-level output;
Float for High-level output
adapter to
Vehicle's
antenna
Vehicle
Ground
12 VDC
Ignition
Vehicle Speakers
LR (-)
LR (+)
RR (-)
RR (+)
LF (-)
LF (+)
RF (-)
RF (+)
Stereo System Out
LR (-)
LR (+)
RR (-)
RR (+)
LF (-)
LF (+)
RF (-)
RF (+)
antenna