Garmin Zumo 590 Manuel d'instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin Zumo 590. Garmin Zumo 590 36 pages. Zumo 590
Également pour Garmin Zumo 590 : Manuel du propriétaire (26 pages), Manuel de démarrage rapide (6 pages), Manuel du propriétaire (26 pages), Manuel d'instructions d'installation (46 pages)

Garmin Zumo 590 Manuel d'instructions d'installation
zūmo
590 Installation Instructions
®

Mounting Your Device in a Motorcycle

About the Powered Mount Cables
Garmin strongly recommends having an experienced installer
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The device must be mounted in a suitable and secure location
on your motorcycle, based on available power sources and safe
cable routing.
Motorcycle cradle
Bare wires with inline fuse for power connection (to motorcycle
power)
Installing the Handlebar Base
The device includes parts for two handlebar installation
solutions. Custom mounts can require additional hardware
(http://www.ram-mount.com).
Installing the U-bolt and Handlebar Base
1
Place the U-bolt
around the handlebar
ends through the handlebar base
2
Tighten the nuts to secure the base.
NOTE: The recommended torque is 50 lbf-in (5.65 N-m). Do
not exceed torque of 80 lbf-in (9.04 N-m).
Installing the Handlebar Base to the Clutch-Clamp or Brake-
Clamp Brackets
1
Remove the two factory bolts on your clutch-clamp or brake-
clamp bracket
.
2
WARNING
, and thread the
.
NOTE: Both 1/4 in. standard and M6 bolts are included.
Match the size of the factory bolts on your clutch-clamp or
brake-clamp bracket.
2
Thread the new bolts
, and clutch-clamp or brake-clamp bracket.
3
Tighten the bolts to secure the base.
Attaching the Base Plate to the Motorcycle Mount
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 40 mm panhead screws
washers
, cradle, spacers
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base
base plate
with each end of the double-socket arm
2
Insert each ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
Installing Your Device in the Motorcycle Mount
1
Fit the bottom of your device into the cradle.
through the handlebar base, spacers
NOTICE
through the
, and base plate
.
and the ball of the
.