Garmin zumo 595 Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Garmin zumo 595. Garmin zumo 595 30 pages.
Également pour Garmin zumo 595 : Manuel d'instructions d'installation (46 pages)

Imprimer la page
Garmin zumo 595 Manuel du propriétaire

Installation

Mounting Your Device in a Motorcycle

Powered Motorcycle Mount

Garmin
strongly recommends having an experienced installer
®
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The device must be mounted in a suitable and secure location
on your motorcycle, based on available power sources and safe
cable routing.
Motorcycle cradle
12 to 24 Vdc system power (red) with in-line fuse
System ground (black)
Motorcycle Mount Wiring Harness
USB
12 to 24 Vdc system power (red) with in-line fuse
System ground (black)
2.5 mm microphone
3.5 mm stereo line-out audio
3.5 mm stereo line-in audio

Installing the Handlebar Base

The device includes parts for two handlebar installation
solutions. Custom mounts may require additional hardware.
Installing the U-bolt and Handlebar Base
1
Place the U-bolt
around the handlebar
ends through the handlebar base
2
Tighten the nuts to secure the base.
NOTE: The recommended torque is 50 lbf-in (5.65 N-m). Do
not exceed torque of 80 lbf-in (9.04 N-m).
Installation
WARNING
, and thread the
.
Installing the Handlebar Base to the Clutch-Clamp or Brake-
Clamp Brackets
1
Remove the two factory bolts on your clutch-clamp or brake-
clamp bracket
.
NOTE: Both 1/4 in. standard and M6 bolts are included.
Match the size of the factory bolts on your clutch-clamp or
brake-clamp bracket.
2
Thread the new bolts
, and clutch-clamp or brake-clamp bracket.
3
Tighten the bolts to secure the base.

Attaching the Base Plate to the Motorcycle Mount

Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
washers
, cradle, spacers
2
Tighten the nuts to secure the base plate.

Attaching the Base Plate to the Handlebar Base

1
Align the ball of the handlebar base
base plate
with each end of the double-socket arm
through the handlebar base, spacers
NOTICE
through the
, and base plate
.
and the ball of the
.
1