Garmin GPS 19x NMEA 0183 Manuel d'instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GPS 19x NMEA 0183. Garmin GPS 19x NMEA 0183 19 pages. Garmin gps receiver - car gps user manual
Également pour Garmin GPS 19x NMEA 0183 : Manuel d'instructions d'installation (8 pages), Manuel d'instructions d'installation (48 pages), Manuel d'instructions d'installation (6 pages), Manuel d'instructions d'installation (6 pages)

Surface Mounting the Antenna

If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a

clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer

when the screws are tightened.

Before you permanently mount the antenna, you must test the mounting location for correct operation

the Mounting Location, page

1 Using the surface-mount bracket

trace the cable-hole in the center of the bracket.

2 Set the surface-mount bracket aside.

Do not drill through the bracket.

3 Drill the three 3.2 mm (

4 Drill the 25 mm (1 in.) cable hole in the center.

5 Use the included M4 screws to secure the surface-mount bracket to the mounting surface.

6 Route the cable

through the center hole, and connect it to the antenna.

7 Verify the large gasket

bracket, and twist it clockwise to lock it in place.

8 Secure the antenna to the mounting bracket with the included M3 screw

9 Route the cable away from sources of electronic interference.

3).

as your mounting template, mark the three pilot-hole locations and

in.) pilot holes.

is in place on the bottom of the antenna, place the antenna on the surface-mount

NOTICE

(Testing