Brother 885-X03 Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Brother 885-X03. Brother 885-X03 48 pages.
Également pour Brother 885-X03 : Manuel d'utilisation (48 pages), Manuel d'utilisation (48 pages)

Imprimer la page

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Pass the end of the thread through the

hole on the bobbin from the inside of the

bobbin.

Put the bobbin onto the bobbin winder

shaft and slide the bobbin winder shaft to

the right. Turn the bobbin clockwise, by

hand, until the spring on the shaft slides

into the notch of the bobbin.

• Make sure to pull out 7 to 10 cm (3-4 inches)

of thread from the hole on the bobbin.

1 Spring on the shaft

2 Notch

3 7-10 cm (3 – 4 inches)

CAUTION

●

Pull the thread taut and hold the end of

the thread straight up. If the thread is too

short, not pulled taut or held at an angle,

injuries may occur when the thread is

wound around the bobbin.

Turn on the machine.

CAUTION

●

Do not turn on the machine while pressing

down the foot controller. The machine

may start unexpectedly and cause

personal injury or damage to the machine.

While holding the end of the thread,

gently press the foot controller to wind

the thread around the bobbin a few times.

Then stop the machine.

Trim the excess thread above the bobbin.

• Leave 1 cm (1/2 inch) of thread from the hole

on the bobbin.

1 1 cm (1/2 inch)

CAUTION

●

Make sure you follow the instructions

carefully. If you do not cut the excess

thread completely before winding the

bobbin, when the thread runs low it may

tangle around the bobbin and cause the

needle to break.

Press the foot controller to start.

When the bobbin seems full and begins

spinning slowly, take your foot off the foot

controller.

Cut the thread, slide the bobbin winder

shaft to the left and remove the bobbin.

Note

● When the sewing machine is started or the

handwheel is turned after winding the

thread around the bobbin, the machine will

make a clicking sound; this is not a

malfunction.

● The needle bar does not move when you

slide the bobbin winder shaft to the right.