Brother 885-X13 Manuel d'utilisation - Page 9

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

CAUTION

●

Before replacing the needle, place fabric

or paper under the presser foot to

prevent the needle from falling into the

hole in the needle plate.

Hold the needle with your left hand, and

4

then use an oval screwdriver to turn the

needle clamp screw counterclockwise to

remove the needle.

1 Use an oval screwdriver

2 Needle clamp screw

• Do not use excessive force when loosening

or tightening the needle clamp screw,

otherwise certain parts of the sewing

machine may be damaged.

With the flat side of the needle toward the

5

back of the machine, insert the needle

until it touches the needle stopper. Next,

tighten the needle clamp using an oval

screwdriver.

Install the twin needle in the same way.

2 1

2

3

1 Use an oval

1

screwdriver

2 Needle stopper

3 Needle

CAUTION

●

Make sure you insert the needle until it

touches the stopper, and securely tighten

the needle clamp screw with an oval

screwdriver, otherwise the needle may

break or the machine may be damaged.

CAUTION

●

Always turn off the machine before you

change the presser foot. If you leave the

power on and step on the controller, the

machine will start and you may be

injured.

●

Always use the correct presser foot for

the stitch pattern you have chosen. If

you use the wrong presser foot, the

needle may strike the presser foot and

bend or break, and may cause injury.

●

Only use presser feet that have been

designed to be used with this machine.

Using any other presser foot may cause

accident or injury.

You will have to change the presser foot depending on

what you want to sew and how.

Turn off the machine.

1

Raise the presser foot lever.

Raise the needle by turning the

2

handwheel toward you

(counterclockwise) so that the mark on

the wheel points up.

Press the black button at the back of the

3

presser foot holder to release the presser

foot.

1

2

3

Put a different presser foot on the needle

4

plate so that the bar on the presser foot is

in line with the slot on the shank.

1 Black button

2 Presser foot holder

3 Presser foot

8

1