Garmin zumo Manuel d'instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin zumo. Garmin zumo 22 pages.
Imprimer la page
2
Tighten the nuts to secure the base
plate.
Attaching the Base Plate to the Handlebar
Base
1
Align the ball of the handlebar base
CD
and the
ball of the base plate
@
with the double-socket
arm @.
2
Insert the ball into the double-socket arm.
3
Tighten the knob
slightly.
4
Adjust for optimal viewing and
operation.
5
Tighten the knob to secure the mount.
6
Align the ball of the base plate attached to the
cradle
@
with the other end of the double-socket
arm.
7
Repeat steps
2-4.
Installing Your Device in the Motorcycle
Mount
1
Fit the bottom of your device into the cradle.
2
Tilt the device back until it snaps into
place.
NOTE: If the latch on top of the mount stays up
after you insert the
device,
press it down.
Removing Your Device from the
Motorcycle Mount
1
Press the button on the side of the mount.
2
Lift out the device.
3
On the motorcycle
mount,
place the weather cap
on the power connector in the center of the cable
(page 2).
Mounting Your Device in an
Automobile
NOTICE
Before mounting the
device,
check the local laws
pertaining to windshield mounting.
&,WARNING
This product contains a lithium-ion battery. To
prevent the possibility of personal injury
or
product
damage caused by battery exposure to
extreme
heat, store the device out of direct sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important Safety and Product Information
guide in the product box for product warnings and
other important information.
Pull back the weather cap on the back of the
cradle.
2
Plug the automotive power cable
CD
into the
mini-USB connector
@
under the weather cap.
3
Remove the clear plastic from the suction cup.
4
Clean and dry your windshield and the suction
cup with a lint-free
cloth.
5
Press the suction cup
@
to the
windshield,
and
flip the lever
®
back toward the windshield.
6
Snap the cradle
@
onto the suction cup arm.
7
Fit the bottom of your device into the cradle.
8
Tilt the device back until it snaps into place.
TIP: Press on the logo at the top of the device
while holding the tab at the top of the
cradle.
9
Plug the other end of the automotive power cable
into a power outlet.
Instructions d'installation du
zumo®
Montage de votre appareil sur une
moto
A propos des cables d'alimentation
,
AVERTISSEMENT
Garmin vous recommande fortement de fa ire
installer l'appareil par un technicien
experimente,
disposant des connaissances appropriees en
matiere de circuits electriques. Le raccordement
incorrect du cable d'alimentation peut endommager
le vehicule au Ia batterie et entralner des blessures
corporelles.
Consultez le guide Informations importantes
relatives au produit et
a
Ia securite inclus dans
l'emballage du produit pour prendre connaissance
des avertissements et autres informations
importantes sur le produit.
L'appareil doit etre monte
a
un endroit ada pte et sOr
de votre
mota,
en fonction des sources
d'alimentation disponibles et de l'acheminement des
cables.