Garmin Approach G5 - GPS-Enabled Golf Handheld Manuel d'entretien - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Garmin Approach G5 - GPS-Enabled Golf Handheld. Garmin Approach G5 - GPS-Enabled Golf Handheld 25 pages. Electronic flight instrument
Également pour Garmin Approach G5 - GPS-Enabled Golf Handheld : Manuel du propriétaire (13 pages), Manuel du propriétaire (17 pages), Informations importantes sur la sécurité et le produit (46 pages), Déclaration de conformité (6 pages), Manuel du propriétaire (20 pages), Manuel du pilote (21 pages)

3. Reconnect the pitot and static lines to the G5 unit. The ports are labeled on the unit using the

abbreviations "P" and "S" respectively.

4. Insert the alignment pin located at the top of the unit into the mating hole in the mounting ring,

pushing the unit flush with the instrument panel.

5. Insert a hex drive tool through the access hole in the front cover of the G5 as shown in Figure 6-1

and tighten the unit to the instrument panel using 10-12 in-lbs torque.

6. Proceed to Section 7 for configuration and testing.

Note: If a replacement G5 unit is being installed in an instrument panel greater than 0.150 inch thick, the

captive mounting screw must be replaced with a longer #6-32 hex socket head screw. To replace the

captive mounting screw, remove the two #4-40 flat head Phillips mount plate screws, the G5 screw mount

plate, and the captive screw as shown in Figure 6-2. Install a longer #6-32 hex socket head screw and

reinstall the screw mount plate. Ensure correct orientation of the screw mount plate before applying 6-8

in-lb. of torque to the #4-40 mount plate screws.

6.2 G5 Battery

Removal

1. Loosen the G5 unit per Section 6.1. Do not remove the pitot and static lines or the electrical and

GPS coaxial cable connectors from the G5 unit if access to the battery can be gained while these

items remain connected.

2. Use a screwdriver to loosen the battery jackscrews on the back of the unit (reference

3. Remove the battery from the G5 unit.

Reinstallation

1. Locate the battery on the back of the G5 unit.

2. Use a screwdriver to tighten the battery jackscrews to back of the G5 unit.

3. Reinstall the G5 unit per Section 6.1.

Garmin G5 Electronic Flight Instrument Part 23 AML STC Maintenance Manual

Page 11 of 18

Figure 5-3

190-01112-11

Rev. 1