Garmin GNS 430 Réflexion rapide - Page 14

Parcourez en ligne ou téléchargez le pdf Réflexion rapide pour {nom_de_la_catégorie} Garmin GNS 430. Garmin GNS 430 17 pages. Friendlypanels gps for microsoft fs9 & fsx
Également pour Garmin GNS 430 : Manuel du pilote (22 pages), Manuel d'instructions (6 pages), Addendum au manuel du pilote (27 pages), Addendum au manuel du pilote (4 pages), Référence rapide (23 pages), Addendum au manuel du pilote (22 pages), Spécifications (2 pages), Manuel d'utilisation du pilote (10 pages), Manuel d'utilisation (27 pages)

Imprimer la page
Garmin GNS 430 Réflexion rapide

Activating an Approach

1. With an approach loaded in the active
flight plan, press
P
to display the
procedures page.
2. Rotate the large right knob (
highlight “Activate Approach?”.
3. Press
E
.
The "Activate Vector-To-Final?" option allows you to activate the final
course segment of the approach. This option assumes you will receive vec-
tors to the final approach fix (FAF) and guides you to intercept the final
course, before reaching the FAF.
Activating an Approach with Vectors-To-Final
1. With an approach loaded in the active
P
flight plan, press
to display the
procedures page.
2. Rotate the large right knob (
highlight “Activate Vector-To-Final?”.
3. Press
E
.
14
d
) to
d
) to
APPROACHES

Flying an Approach

Due to the variety of available approach procedures, the specific steps
required will vary according to the approach selected. Keep the following
general guidelines in mind while flying the approach:
• You will typically select the destination airport as the last waypoint in
the active flight plan or using the
desired waypoint will automatically appear when choosing the
"Select Approach?" option from the procedures page. (Otherwise, you
must first choose the airport, then the approach procedure.)
• When a localizer-based approach (such as an ILS) is loaded, the
desired frequency is automatically placed in standby on the VLOC
window. To activate the frequency, press the
• If the VLOC receiver will be used for the approach, be sure to switch
the external CDI (or HSI) to "VLOC" by pressing the
("VLOC" will appear directly above the
• An "Auto ILS CDI" setting provides automatic switching to "VLOC"
once established inbound on the final course segment of an approach.
• As you progress to each approach waypoint, a waypoint alert message
("NEXT DTK ###°") will appear in the lower right corner of the
display. (See page 10.)
• When you should begin a course change (via a standard rate turn),
turn advisories ("TURN TO ###°") will appear in the lower right
corner of the display. (See page 10.)
D
key. Doing so ensures that the
V
key.
C
C
key; see page 10).
key