the Flight Plan or Procedures portion of the system. The absence of a particular
Departure, Arrival, or Approach under the Flight Plan or Procedures portion of
the system does not preclude the ability to view the Chart for that procedure
under the Chart feature.
The following list on chart loading priority was added on page 7-2:
The following list describes the order in priority in which charts are auto-loaded in the
system when the Chart page is displayed:
1. The most-recently selected chart during the current power cycle, if valid*,
2. The airport surface chart for the nearest airport, if on ground and nearest airport is
found,
3. The approach chart for the approach in the active flight plan, if an approach exists in the
flight plan,
4. The airport surface chart for the last airport in the flight plan, if one exists,
5. The airport surface chart for the nearest airport, if nearest airport is found (same as #2
but aircraft could be in-air),
6. The airport surface chart for the first airport in the database, if found,
7. No chart.
* "Selected" does not include charts that were auto-selected. A selection must be made
while on the charts page.
There following actions will invalidate #1:
• Changing the approach in the active flight plan
• Changing the on-ground status while not viewing the Charts page
Messages
Page
Message
17-2
AUDIO PANEL -
Audio panel is
inoperative or
connection to GTN
is lost.
17-4
CONFIGURATION
- Terrain/TAWS
configuration is invalid.
GTN needs service.
190-01007-09 Rev. A
190-01007-09_0A.indd 3
Description
The GTN is configured for
Garmin audio panel control
(GMA 35) and the GTN
cannot communicate with
the GMA 35. No control
of the GMA 35 will be
possible.
TAWS is inoperative due
to a configuration problem
with the GTN. This message
will be accompanied by a
TER FAIL annunciation.
Garmin GTN Pilot's Guide Errata 1
Action
Remove power from the GMA
35 audio panel by pulling
the circuit breaker labeled
"Audio." The pilot will be able
to communicate with the Com
2 radio. Contact dealer for
service.
Contact dealer for service.
3
3/1/2011 2:21:13 PM
Imprimer la page