AlkaWay UltraStream 420080 Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AlkaWay UltraStream 420080. AlkaWay UltraStream 420080 2 pages.

Imprimer la page

To connect an UltraStream on your bench top to a dedicated tap

Included is everything you need to install your UltraStream on its own dedicated tap.

Position and drill the tap hole

Locate a position on the bench top or sink with enough room to ensure the tap can be turn on and off

and make sure you can access the hole from under the sink.

1. Place tape over the spot where you are to drill to allow the drill to stay centred,

2. Drill a hole between 12.7mm - 25mm (1/2" to 1" inch) hole in sink top. Drilling in stone will

require an expert,

3. Remove burrs and any sharp edges around the hole before installing the tap.

Installing the tap

1. Remove brass nut, washer (unscrew) and plastic black disc from the tap assembly,

2. Feed the tap tube through the hole in the sink and position the tap,

3. Feed the black plastic disc, brass washer and nut back onto the tube. Firmly tighten the nut into

place.

Version 3 - Dec 18