Garmin GPS 17 Series Manuel d'instructions d'installation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GPS 17 Series. Garmin GPS 17 Series 19 pages. Technical specifications
Également pour Garmin GPS 17 Series : Manuel d'instructions d'installation (16 pages), Manuel d'instructions d'installation (17 pages), Spécifications techniques (37 pages)

Final Wiring Connection

After all the wiring is complete, the cables are attached on the back of the GPSMAP 3006C/3010C MFD. If the MFD is not being networked,

be sure to ﬁrmly afﬁx the weather cap over the open connector to limit corrosion of the contacts. The connection ports are labeled on the back

of the MFD.

To install the Power/NMEA, Marine Video, and Network Cables:

1. Align the notch and locking ring tab on the black Power/NMEA cable with the black POWER/NMEA port on the back of the unit. Carefully

press the cable in until it is ﬁrmly seated. Do not force the cable, as this may damage the pins!

2. After the cable is seated, turn the locking ring clockwise until it stops.

3. Repeat steps 1 and 2, attaching the gray Marine Video cable to the gray VIDEO port on the back of the unit.

4. If networking the MFD with the Garmin Marine Network, insert the RJ-45 connector into the NETWORK port on the back of the unit and

screw the locking ring in clockwise until it is ﬁrmly seated.

With power applied to the circuit, test the installation by pressing the POWER key on the front of the unit. See the GPSMAP 3006C/3010C

Owner's Manual for steps on initializing the receiver.

GPSMAP 3006C/3010C & GPS 17

GPSMAP 3006C

Connection ports

GPSMAP 3010C

Connection ports

NSTALLATION

NSTRUCTIONS