Garmin GPSMAP 4008 - Marine GPS Receiver Manuel d'instructions d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GPSMAP 4008 - Marine GPS Receiver. Garmin GPSMAP 4008 - Marine GPS Receiver 19 pages. Weather and xm satellite radio gpsmap 4000 series; gpsmap 5000 series; gpsmap 6000 series; gpsmap 7000 series
Également pour Garmin GPSMAP 4008 - Marine GPS Receiver : Important Information (2 pages), Manuel du propriétaire (2 pages), Référence technique (30 pages), Manuel de référence rapide (2 pages), Manuel d'instructions d'installation (25 pages), Manuel d'instructions d'installation (25 pages), Manuel de référence rapide (2 pages), Informations importantes en matière de sécurité (48 pages), Déclaration de conformité (1 pages), Manuel complémentaire (24 pages)

Wiring and Cables

The GPSMAP 4000/5000 series unit comes with a power cable, a 19-pin NMEA 0183 data cable, and a 17-pin Marine Video cable. Optional

Garmin Marine Network components use specialized Garmin Network cables. Depending on the installation, it may be necessary to drill holes to

route the connector end of these cables. Garmin rubber grommets are provided to cover these holes for a finished look.

You may not need the grommets in some installations. The grommets do NOT

create a waterproof seal. Apply a marine sealant around the grommet and

cable after installation. Be sure to test the system before installing and sealing

the grommets. Purchase additional grommets from your Garmin dealer or

directly from Garmin at www.garmin.com.

Tools

•

Drill

•

" (31.7 mm) paddle drill bit or hole saw

•

Utility knife

•

Marine sealant (optional)

To install the cable grommet:

1. Mark the location where you want to route the power, NMEA 0183,

Marine Video, or Marine Network cable.

2. Using a

(31.7 mm) paddle drill bit or hole saw, drill the installation hole.

3. Refer to the diagram for trimming instructions. Carefully trim the cable hole in

the grommet, as needed.

4. Route the cable to the unit, and test the system.

5. Spread the grommet apart at the split and place it around the cable.

6. Firmly push the grommet into the installation hole until it is seated. Apply

marine sealant, as needed, to weatherproof the cable.

The GPSMAP 4000/5000 series unit must be connected to the boat's power supply. Use the 2-pin power cable included, and connect the power

(red) and ground (black) wires. Use 14 AWG shielded wiring for extended runs of wire to the power cable. Solder all connections and seal them

with heat shrink tubing.

Ensuring

Trim to this line for

the Marine Video

cable.

GPSMAP 4000/5000 Series Installation Instructions

Use this hole (no trim) for the

power, NMEA, Marine Network,

or GPS 7 cable.

Split