Garmin Fishfinder 300C Manuel d'instructions d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin Fishfinder 300C. Garmin Fishfinder 300C 8 pages. Garmin fish finder - fishfinder user manual
Également pour Garmin Fishfinder 300C : Manuel de démarrage rapide (25 pages), Informations importantes en matière de sécurité (48 pages), Modèle (1 pages), Manuel de démarrage rapide (espagnol) (24 pages)

Step 4: Install the Wiring Harness

The Fishfinder 300C comes with a cable assembly that connects it to power and to the transducer with one connection and provides interface

capabilities for connecting external devices.

The color code in the diagram on

necessary to extend the power wires, use 22 AWG wire. Do not cut the transducer cable. Cutting the transducer cable voids your warranty. If

your boat has an electrical system, you might be able to wire the Fishfinder 300C directly to an unused holder on your current fuse block. If you

are using the fuse block, remove the in-line fuse holder supplied with the Fishfinder 300C. You can also wire the Fishfinder 300C directly to the

battery.

CAUTION: The Fishfinder 300C maximum input voltage is 33 Vdc. Do not exceed this voltage, because this can damage the Fishfinder 300C and void

the warranty.

NOTE: During a typical installation, use only the red and black wires. The other wires do not have to be connected for normal operation of the

Fishfinder 300C. For information on connecting to a NMEA 0183-compatible device, see

To install the wiring harness:

1. Use a test light or voltmeter to determine the polarity of the voltage source.

2. Connect the red (+ or positive) wire to the positive voltage terminal. (If you use the fuse block on the boat, route the positive connection

through the fuse, as shown on the diagram.)

3. Connect the black (- or ground) wire to the negative voltage terminal.

4. Install or check the 3A fuse (on the fuse block or in the in-line holder).

5. Align the notches on the cable plug and on the back of the Fishfinder 300C. Insert the cable into the connector, and turn the locking ring

counter-clockwise until it stops.

page 7

indicates the appropriate harness connections. The replacement fuse is an AGC/3AG 3A fuse. If it is

Boat ground

—

To Fishfinder 300C

Pin 8 - ground (black)

Pin 13 - dc positive (red)

Fishfinder 300C Power/Data

Cable Pin Assignment

page 7.

3A fuse

To 10–38 volt boat supply

Fuse block

Pin 7 - alarm (yellow)

Pin 18 - NMEA out (blue)

Fishfinder 300C Installation Instructions