Garmin GHP 10V Manuel d'instructions d'installation
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GHP 10V. Garmin GHP 10V 20 pages. Marine autopilot system
Également pour Garmin GHP 10V : Manuel d'instructions d'installation (48 pages), Manuel du propriétaire (28 pages), Manuel d'instructions d'installation (20 pages)
To obtain the best possible performance and to avoid damage to your boat, install your GHP 10V marine autopilot system according to the
following instructions. Read all installation instructions before proceeding with the installation. If you experience difficulty during the
installation, contact Garmin Product Support or seek the advice of a professional installer.
The GHP 10V is compatible with C3 or newer Volvo
Product Registration
Help us better support you by completing our online registration today! Connect to our Web site at http://my.garmin.com. Keep the original
sales receipt, or a photocopy, in a safe place.
For future reference, write the serial number assigned to each component of your GHP 10V system in the spaces provided on
numbers are located on a sticker on each component.
Contact Garmin
Contact Garmin Product Support if you have any questions while installing or using your GHP 10V autopilot system. In the USA, go to
www.garmin.com/support, or contact Garmin USA by phone at (913) 397.8200 or (800) 800.1020.
In the UK, contact Garmin (Europe) Ltd. by phone at 0808 2380000.
In Europe, go to
www.garmin.com/support
phone at +44 (0) 870.8501241.
Warnings
•
You are responsible for the safe and prudent operation of your vessel. The GHP 10V is a tool that will enhance your capability to
operate your boat. It does not relieve you from the responsibility of safely operating your boat. Avoid navigational hazards and never leave
the helm unattended.
•
Always be prepared to promptly regain manual control of your boat.
•
Learn to operate the GHP 10V on calm and hazard-free open water.
•
Use caution when operating the GHP 10V at high speeds near hazards in the water, such as docks, pilings, and other boats.
•
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Cautions
•
Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
•
When drilling or cutting, always check the opposite side of the surface. Be aware of fuel tanks, electrical cables, and hydraulic hoses.
•
Do not connect the CCU interface connector on either the CCU cable or the Autopilot Gateway to a NMEA 2000
September 2009
GHP
10V Installation Instructions
™
EVC systems. Contact Volvo for information on updating older EVC systems.
®
Contact Support
and click
190-01082-02 Rev. B
for in-country support information, or contact Garmin (Europe) Ltd. by
page
2. The serial
network.
®
Printed in Taiwan