Garmin GHP 12 Manuel d'instructions d'installation
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GHP 12. Garmin GHP 12 32 pages. Drive unit and rudder feedback unit wiring reference
Également pour Garmin GHP 12 : Manuel de référence (2 pages)
Imprimer la page
GHP
12 Installation Instructions
™
This revision was written to software version 2.2 of the GHP 12, which
added solenoid drive unit compatibility.
To obtain the best possible performance and to avoid damage to your
boat, install the Garmin
GHP 12 marine autopilot system according
®
to the following instructions. Professional installation of the autopilot
system is highly recommended. Specific training in steering systems
and in marine electrical connections is required to properly install the
autopilot system.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation, contact
Garmin Product Support.
NOTE: There is an installation checklist on the last page of these
instructions. Remove the last page and refer to the checklist as you
proceed through the GHP 12 installation.
Registering the Device
• Go to http://my.garmin.com.
• Keep the original sales receipt, or a photocopy, in a safe place.
For future reference, write the serial number assigned to each
component of your GHP 12 system in the spaces provided on
The serial numbers are located on a sticker on each component.
Contacting Garmin Product Support
• Go to
www.garmin.com/support
country support information.
• In the USA, call (913) 397.8200 or (800) 800.1020.
• In the UK, call 0808 2380000.
• In Europe, call +44 (0) 870.8501241.
July 2011
page
and click Contact Support for in-
190-01289-02 Rev. B
Important Safety Information
You are responsible for the safe and prudent operation of your
vessel. The GHP 12 is a tool that will enhance your capability to operate
your boat. It does not relieve you from the responsibility of safely
operating your boat. Avoid navigational hazards and never leave the
helm unattended.
Always be prepared to promptly regain manual control of your boat.
Learn to operate the GHP 12 on calm and hazard-free open water.
Use caution when operating the GHP 12 near hazards in the water, such
as docks, pilings, and other boats.
See the Important Safety and Product Information guide in the product
box for product warnings and other important information.
Equipment to be connected to this product should have a fire enclosure
or be provided with a fire enclosure.
Always wear safety goggles, ear protection, and a dust mask when
drilling, cutting, or sanding.
When drilling or cutting, always check the opposite side of the surface.
Be aware of fuel tanks, electrical cables, and hydraulic hoses.
3.
WaRnInGS
CautIon
Notice
Printed in Taiwan