Garmin GWS 10 Marine Wind Sensor Référence technique - Page 8

Parcourez en ligne ou téléchargez le pdf Référence technique pour {nom_de_la_catégorie} Garmin GWS 10 Marine Wind Sensor. Garmin GWS 10 Marine Wind Sensor 42 pages. Marine sensor
Également pour Garmin GWS 10 Marine Wind Sensor : Manuel d'instructions d'installation (43 pages), Manuel d'instructions d'installation (44 pages), Informations importantes en matière de sécurité (48 pages), Manuel de configuration (2 pages), Déclaration de conformité (1 pages), Instructions d'installation (42 pages)

Imprimer la page
Garmin GWS 10 Marine Wind Sensor Référence technique
NMEA 2000 Fundamentals
Linear Backbone Construction
Use the NMEA 2000 T-connectors to construct your NMEA 2000 backbone, and extend the backbone with appropriate lengths of backbone
cable if necessary. Use one T-connector per device. Use the sides of the T-connector to construct the backbone of the NMEA 2000 network, and
use the top of the T-connector to attach a NMEA 2000 device. By using only the sides of the T-connectors to construct the backbone, you create
a linear construction to your NMEA 2000 network. T-connectors can be separated by backbone cables or connected directly together.
Although the male and female connectors on the T-connectors and backbone cables will fit on all sides of a T-connector, it is very important to
use the top of the T-connector only to attach NMEA 2000 devices, not to attach other T-connectors or backbone cables.
To NMEA 2000 devices
and power
Female
terminator
Male
Backbone extension cable
terminator
Correct Linear Backbone Construction
To NMEA 2000 devices
and power
T-connector
installed incorrectly
Male
terminator
Male
Backbone extension cable
(also installed
terminator
incorrectly)
Incorrect Linear Backbone Construction
Technical Reference for Garmin NMEA 2000 Products