Garmin LIVESCOPE Manuel d'instructions d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin LIVESCOPE. Garmin LIVESCOPE 6 pages.

3 Place the base

between the handle

4 Determine how many of the three middle pole segments you need to use, based on the thickness of the ice.

TIP: The top of the transducer must be below the bottom of the ice for best performance.

5 Screw together the needed segments, with the shortest segment on the bottom of the pole.

6 Use the included hex wrench to attach the transducer

washer

, and rubber washer

NOTE: You must fully tighten the shoulder screw to secure the transducer to the bracket. The recommended

torque applied to the shoulder screw is 2.5 lb-ft. (3.4 N-m).

7 Using the hex wrench and the M6 screws

8 After mounting the transducer on the pole, use the hook and loop straps to secure the transducer cable to

the pole.

and the top pole

to the bracket

, attach the two halves of the bracket around the pole.

, and screw them together.

with the shoulder screw

, flat