AEG FAVORIT 44010 VI Manuel de l'utilisateur - Page 37
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG FAVORIT 44010 VI. AEG FAVORIT 44010 VI 40 pages. Electrolux dishwasher user manual
Imprimer la page
Electrical connection
37
The total length of the drain hose, including any extension you might add, must
be no longer than 4 metres. The internal diameter of the extension hose must be
no smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for connections to the waste
outlet must be no smaller than the diameter of the hose provided.
When connecting the drain hose to an under sink trap spigot, the entire plastic
membrane (A) must be removed. Failure to remove all the membrane will result
in food particles building up over time eventually blocking the dishwasher drain
hose spigot.
Our appliances are supplied with a security device to
protect against the return of dirty water back into the
machine. If the spigot of your sink has a "no return valve"
incorporated this can prevent the correct draining of
your dishwasher. We therefore advise you to remove it.
To avoid water leakage after installation make sure that
the water couplings are tight.
Electrical connection
WARNING!
Safety standards require the appliance to be earthed.
Prior to using the appliance for the first time, ensure that the rated voltage and
type of supply on the rating plate match that of the supply where the appliance is
to be installed.
The fuse rating is also to be found on the rating plate.
Always plug the mains plug into a correctly installed shockproof socket. Multi-way
plugs, connectors and extension cables must not be used.
This could constitute a fire hazard through overheating.
If necessary, have the domestic wiring system socket replaced. In case that the
electrical cable has to be replaced, contact your local Service Force centre.
The plug must be accessible after the appliance has been installed.
Never unplug the appliance by pulling on the cable. Always pull the plug.
The manufacturer accepts no liability for failure to observe the above safety pre-
cautions.