AEG FAVORIT 55020 W0P Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG FAVORIT 55020 W0P. AEG FAVORIT 55020 W0P 16 pages. Dishwasher
Imprimer la page
10 www.aeg.com
5. Set and start the correct programme
for the type of load and the degree
of soil.
7.1 Using the detergent
A
7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation all the phase indica-
tors come on. The time of the last set
programme flashes in the display.
If the control panel shows other condi-
tions, press and hold Multitab and De-
lay at the same time until the appliance
is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Close the appliance door.
4. Turn the programme knob until the
marker on the knob is aligned with
the programme you want to set.
• The programme duration flashes in
the display.
• The phase indicators of the set
programme come on.
5. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
B
30
A
20
+
-
C
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compart-
ment (A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
3. Press Start. The countdown starts.
• The display shows the countdown
of the delay start that decreases
with steps of 1 hour.
• The phase indicators of the set
programme go off.
• When the countdown is completed,
the programme starts.
– The indicator of the phase in opera-
tion comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.