Fujitsu ABY30TBAG Manuel d'entretien - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Fujitsu ABY30TBAG. Fujitsu ABY30TBAG 29 pages. Ceiling type (50hz)

Imprimer la page

REMOTE CONTROL UNIT CODE SWITCHING

JM1
JM2
JM3
2003.12.12 PRELIMINARY
Indoor unit
Printed circuit board
JM1
Other models
JM2
€ Remote control unit settings
JM3
(1) Press the START/STOP button and display
only the clock.
CLOCK
MASTER
CONTROL
(2) Press the MASTER CONTROL button continuously
for more than five seconds to display the current
signal code.
MASTER
CONTROL
(3) Change the signal code with the
(
).
MASTER
CONTROL
(4) Press the MASTER CONTROL button again to return
to the clock display and change the signal code.
Confirm the setting of the remote control unit signal codes
setting and the printed circuit board setting.
If these are not confirmed, the remote control unit cannot be
used to operate for the air conditioner.
Jumper wire
JM 2
Connect
Connect
Disconnect
Disconnect
Disconnect
Disconnect
SET
SET
FAN
TEMP.
TIME
CONTROL
+
SET
SET
FAN
TEMP.
TIME
CONTROL
+
+
SET
SET
FAN
TEMP.
TIME
CONTROL
+
Remote control unit
signal selector switch
JM 3
Connect
A (Primary setting)
B
Connect
C
D
11
button