a-gear P1004T EPON Manuel d'installation du matériel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} a-gear P1004T EPON. a-gear P1004T EPON 13 pages. Optical network unit

Imprimer la page

1. Access Device

A-GEAR World Wide Manufacturing

Disassembly of the equipment may require some tools, which are not included in standard

configuration of EPON access device. These tools are as follows:

• Cross screwdriver

• Anti-static hand ring

Pleas open the cover of EPON access device according to the following steps.

(1) Pull off power cable of EPON access device;

(2) Pull of all cables connected to EPON access device ports;

(3) Release screws on the equipment outer casing with screwdriver;

Note: The equipment outer casing consists of two parts: equipment cover and equipment base.

(4) Remove the cover in the direction of the arrow as shown in the following figure

(5) When the cover is opened, put it aside. The system mainboard appears.

Note:

After removal of the cover, place it stably to avoid squeezing, collision or deformation, otherwise installation of the

equipment will become difficult.

4.2.

C los e t h e e qu ip m e n t

This part mainly describes the flow for placing cover and closing the equipment.

Please operate according to the following steps:

(1)

Install the equipment cover and base in place according to the direction and

steps in 4.1-(4).

(2)

Re-install the screws and tighten them with screw driver.

(3)

Re-install EPON access device or place it on the desktop.

(4)

Equipment closing work is completed. Re-connect all cables.

A nal ys is of H ard wa re Fail ure

This section describes method for failure analysis and isolation of failure from EPON access

device:

5.1.

Fa i l u re I s o l at io n

The key to settle system failure is to isolate failure from the system. Failure isolation and

settlement becomes easy by comparison between what the system should do and what the

system is doing. The following sub-systems should be considered in solving the problems:

• Power connection;

• Port, cable and link - ports on the front panel of EPON access device and cables

connected to the ports.

5.1. 1.

Powe r f a i l u re

Check the following items to facilitate isolation of problems:

• Confirm that power cable is reliably connected and power is supplied.

• Check the environmental conditions. Note that temperature required for work location

of EPON access device should be -5°C ~ 45°C.

A-GEAR P1004T EPON Optical Network Unit (ONU)

datasheet

a-gear.net

Раge 12 of 13