AEG OKO_FAVORIT 5070 Instructions pour l'utilisateur - Page 35
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} AEG OKO_FAVORIT 5070. AEG OKO_FAVORIT 5070 44 pages. Electrolux user instructions dishwasher 5070
Imprimer la page
Leak Prevention System
For protection from damage due to water leaks, the dishwasher is
equipped with a leak prevention system, the AQUA CONTROL SYSTEM.
In the event of a fault, the drain pump switches on. By this means
water can neither escape nor overflow. The remaining water in the
appliance is automatically pumped out.
The AQUA CONTROL SYSTEM also works when the appliance is switched
1
off – the appliance must however not be disconnected from the mains.
Electrical Connection
Any electrical work required to install this appliance should be car-
ried out by a qualified electrician or competent person.
WARNING - This appliance must be earthed.
1
The manufacturer declines any responsibility should these safety
measures not be observed.
Before switching on make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate.
To isolate the dishwasher from the mains, remove the mains plug.
Important: The plug must still be accessible after the appliance has
been installed.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In the event of hav-
ing to change the fuse in the plug supplied, a 13amp ASTA approved
(BS 1363A) fuse must be used.
Should the plug need to be
replaced for any reason, proceed as
described below.
The wires on the mains lead are col-
oured in accordance with the fol-
lowing code.
Green and Yellow : Earth
Blue
Brown
Installation and Connection Instructions
: Neutral
: Live
Green
& Yellow
Blue
Cord Clamp
Brown
35