AEG VVW6020A Manuel d'instruction - Page 39

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} AEG VVW6020A. AEG VVW6020A 48 pages. 12 place settings

cleaning & maintenance

Cleaning the dishwasher regularly, prolongs the dishwasher's service life.

Check before cleaning the dishwasher if it's is turned off. Unplug the dishwasher and turn off the tap.

Clean the outside of the dishwasher with a damp cloth. To prevent odors from forming within the dishwasher, clean the seals of the

door regularly with a soft damp cloth.

To prevent the dishwasher from getting clogged, we advise to clean the dishwasher regularly with a special cleanser. Fill the detergent

reservoir with detergant, select a cycle with a high temperature and start the program. If this is insufficient, use a special cleanser for

dishwasher and follow the instructions on the packaging.

Clean the filters and the spray arms once a week.

Check once a week if there is any residue on the filters. Remove the filters and clean them thoroughly under the water tap.

The filter system consist of three components: the main filter (1), the sieve (2) and the micro filter (3).

1. To remove the filters, turn the main filter (1) anti-clockwise and pull it upwards. The micro filter (3) is

attached to the main filter.

2. Pull the main filter from the micro filter and clean both parts with warm water using a dishwashing brush.

3. Take the sieve (2) out of the dishwasher and clean it with warm water and if needed a dishwashing brush.

Place the sieve back in the dishwasher.

4. Place the main filter in the micro filter with the markings allined. Re-fit the filters in the sieve and turn it

clockwise to fixe it.

• Do not use the dishwasher when there are no filters in place.

• Incorrect fitting of one the filters will result in the dishwasher no longer delivering maximum

performance.

• Make sure the filters are clean. This ensures proper functioning of the dishwasher.

Check the nozzles of the upper and lower spray arms regularly for waste. Waste can block the nozzles and bearing in the spray arms.

Remove the clogging in the spray arms and clean them with warm water.

• Unscrew the nut of the upper spray arm to remove it. Remove the spray arm.

• Remove the lower spray arm by pulling it upwards.

• Clean the spray arm with warm water.

• Make sure that the nut is perfectly tightened when refitting the upper spray

arm.

English

•