A-I-R ATOS Series Manuel d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} A-I-R ATOS Series. A-I-R ATOS Series 20 pages.

20 .) Insert the wing tip rod.

2 1 .) Velcro the sail to the winglet.

22.) Repeat steps 15 to 21 on the other wing.

23.) If using split bags: hook up the pulley block of the tensioning rope to the sail.

Begin to tension the sail, but only partially.

25.) Before fully tensioning the sail, check that the outer 3 ribs are still securely inserted and

secured. Check t hat the aluminum wing outer tubes are correctly inserted up to the triangle

mark, the carbon shells are correctly positioned and the wind tip rods are still seated.

26.) Tension the sail carefully up to the mark on the rope. Check that the rope is correctly routed

through the block and tackle. Make sure the rope is secured in the cleat.

27.) Connect the sail ring to the keel and use the lever to attach the other side. Make sure the

push button behind the control frame attachment is out , keeping the lever engaged.

28.) Mount the tail unit. Tighten the bolt hand-tight using the assembly wrench.

29.) Wind up the tension rope and stow it in the tail bag. Then place the bag as far as

possible under sail trailing edge near the keel .

30.) C lose the upper sail zipper .

31.) Insert the flap pivot pins into the flaps, se t the flaps to the take-off position.

32.) Connect the spoiler to the spoiler lever with the bungee.

33.) Visually inspect the wing and all the control surfaces.

Page 7

24.)