Brother HL-1040 Manuel d'installation rapide - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Brother HL-1040. Brother HL-1040 42 pages. Brother hl-1040: quick setup
Également pour Brother HL-1040 : Liste de référence des pièces (16 pages)

Imprimer la page

For errors shown below, the printer indicates an operator call by blinking the Alarm lamp. If

you use the printer with the supplied Windows driver, the status monitor will appear to

indicate the error on your computer screen. The HL-1040/1050 printer also prints some error

messages on paper.

Error

Cover Open

Print Overrun

Memory Full

(For HL-1040/1050

Only)

This error can occur only

when using DOS or

Macintosh.

Parallel Interface Line

Error

Serial Interface Framing

Error (For HL-

1040/1050 Only)

Serial Interface Parity

Error (For HL-

1040/1050 Only)

Serial Interface Overrun

Error (For HL-

1040/1050 Only)

Action

Close the top cover of the printer.

Press the panel switch to print the data remaining in the

printer.

If you use the supplied Windows driver, try again after turning

on Error Recovery in the PRINT menu of your application

software, (Refer to Help section in Windows printer driver for

the details.)

(For HL-1050 only)

Expand the printer memory with an optional memory board and

set page protection to ON by using the supplied Windows

driver or RPC program.

(For HL-1050 only)

Change the following settings in the supplied Windows driver

and try again. The best combination of the settings below will

vary depending on your document.

Graphics Mode

TrueType mode

Use Printer TrueType Fonts

If this does not clear the error, reduce the complexity of your

document or reduce the print resolution.

Press the panel switch to print the data remaining in the

printer.

Reduce the print resolution or reduce the complexity of your

document.

(For HL-1050 only)

Expand the printer memory by adding a commercially available

SIMM.

Press the panel switch to resume printing.

Check that the connection between your computer and printer is

secure and correct, and check the interface cable.

Press the panel switch to resume printing.

Check the communication parameters such as baud rate and

stop bit settings on both your computer and printer.

Press the panel switch to resume printing.

Check the communication parameters such as bit length and

parity settings on both your computer and printer.

Press the panel switch to resume printing.

The interface hardware may be damaged. Consult your dealer.

-31-