Brother HL-1250 Manuel d'installation rapide - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Brother HL-1250. Brother HL-1250 16 pages. Imprimante laser
Également pour Brother HL-1250 : Manuel d'installation rapide (16 pages), Liste de référence des pièces (25 pages), Manuel d'entretien (8 pages), (français) Manual De Configuration Rapide (16 pages)
Imprimer la page
Troubleshooting
Problem
All the LEDs are off
Alarm LED illuminates
Alarm and Ready LEDs
are blinking
Alarm and Data LEDs are
blinking
The printer does not print
a test page from the
control panel
Data is sent from the PC
but the printer does not
print and the Data LED is
blinking.
The printer prints
unexpectedly or it prints
garbage data.
When you use the Reprint
function the printer does
not print all of the last
print job, only the last
page.
Recommendation
• Check if the printer is in sleep mode.
- Press the control panel button.
• Check that the power plug is connected correctly.
• Check that the printer is turned on.
• Check that the front cover is completely closed.
• Check that the paper is inserted correctly into the paper
cassette or manual feed slot.
• Check if a paper jam has occurred in the printer.
• Check that the drum unit is installed correctly.
• Check if a document has already been printed from your
PC.
- Once you have printed a document from your PC, the
printer cannot print a test page again.
• Check that the appropriate printer driver is selected.
• Check that the printer cable is not too long.
- We recommend you use a parallel cable of less than 2
metres (6.6 feet) in length.
- Exchange it with another one.
• Check that the printer cable is not damaged or broken.
- Exchange it with another one.
• Check if you are using a parallel interface switching
device.
- Remove it and connect your PC directly to your
printer and try again.
• Check that the appropriate printer driver is selected.
• Check that the printer is not connected to a parallel port
that is also connected to a mass storage device or scanner.
• Remove all other devices and connect the port to the
printer only and try it again.
• Turn off printer status reporting in the device options tab
in the printer driver.
• Add memory to the printer. It may still not be possible to
reprint a large print job even after adding memory.