Fujitsu LifeBook B2620 Manuel Bios - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel Bios pour {nom_de_la_catégorie} Fujitsu LifeBook B2620. Fujitsu LifeBook B2620 38 pages. Lifebook b series
Également pour Fujitsu LifeBook B2620 : Manuel Bios (34 pages)
L i f e B o o k B S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed.
Main
Type:
Cylinders:
Heads:
Sectors:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Type:
• Auto
• None
• Hard Disk
Cylinders:
• A number
between 0
and 65,535
Heads:
• A number
between 1
and 16
6
PhoenixBIOS Setup Utility
Advanced
Security
Primary Master [FUJITSU MHM2200AT-(PM)]
[Hard
[16383]
[16]
[63]
8455MB
[16 Sectors]
[Enabled]
[FAST PIO 4]
[Ultra DMA 2]
Select Item
-/Space
Select Menu
Enter
Figure 2. Primary Master Submenu
Default
[Auto]
–—
–—
Note: Actual hard drive label shown may vary. Depending
on the drive type, information such as cylinders, heads and
sectors may also be displayed.
Power
Boot
Info
Select ATA/ATAPI drive
Disk]
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
Select
Sub-Menu
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and
Sectors for the drive. Select ATAPI Removable if a removable disk
drive is installed at this connection.
This item appears only when the type is identifed as Hard Disk.
When Hard Disk is selected, you can change the value. This field is
changed by incrementing (pressing the [Spacebar]) or by typing in
the number.
TThis item appears only when the type is identifed as Auto or Hard
Disk. When Hard Disk is selected, you can change the value. This
field is changed by incrementing (pressing the [Spacebar]) or by
typing in the number.
Exit
Item Specific Help
F9
Setup Defaults
F10
Save and Exit