AEG KO-LAVAMAT 88840 Manuel de l'utilisateur - Page 41
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG KO-LAVAMAT 88840. AEG KO-LAVAMAT 88840 48 pages. Aeg prosteam condenser dryer user manual
Imprimer la page
WARNING!
The power supply cable must be accessible after installing the machine.
Permanent connection
In the case of permanent connection it is necessary that you install a double pole switch
between the appliance and the electricity supply (mains), with a minimum gap of 3 mm
between the switch contacts and of a type suitable for the required load in compliance
with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.
Door reversal
To make is easier to load or unload the laundry, the door can be reversed. This operation
must only be carried out by a qualified engineer. Please contact your local service centre.
The engineer will carry out the door reversal at your cost.
Special accessories
• stacking kit
Available from your Service Force Centre or your specialist dealer
These intermediate installation kits can be used to arrange the dryer and a washing
machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. The washing
machine is at the bottom and the dryer is at the top.
Read carefully the instructions supplied with the kit.
• draining kit
Available from your Service Force Centre or your specialist dealer
Installation kit for direct draining of condensate into a basin, siphon, gully, etc. The
condensate tank then no longer has to be drained, it must however remain in its intended
position in the machine.
Read carefully the instructions supplied with the kit.
• pedestal with the drawer
Available from your Service Force Centre or your specialist dealer
To situate the dryer in optimal high and have some additional space to store (e.g. laundry).
Read carefully the instructions supplied with the kit.
Service
In the event of technical faults, please first check whether you can remedy the problem
yourself with the help of the operating instructions (Chapter "What to do if...").
If you were not able to remedy the problem yourself, please contact your local service
centre.
In order to be able to assist you quickly, we require the following information:
41
Service