Fujitsu LifeBook i Series Manuel Bios - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel Bios pour {nom_de_la_catégorie} Fujitsu LifeBook i Series. Fujitsu LifeBook i Series 37 pages. Fujitsu laptop pc bios guide
Imprimer la page
L i f e B o o k i S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies which ATA
devices are installed.
Note that, although Auto is the default setting for this
Main
Primary Master [TOSHIBA MK6014MAP-(PM)]*
Type:
Cylinders:
Heads:
Sectors:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Type:
Auto
None
CD-ROM
Hard Disk
Cylinders:
A number
between 0
and 65,535
Heads:
A number
between 1
and 16
Sectors:
A number
between 0
and 63
6
PhoenixBIOS Setup Utility
[Hard Disk]
[16383]
[16]
[63]
8455MB
[16 Sectors]
[Enabled]
[Fast PIO 4]
[Ultra DMA 2]
Select Item
-/Space
Select Menu
Enter
Figure 2. Primary Master Submenu
Default
[Auto]
–—
–—
–—
submenu, the Hard Disk setting is illustrated, since it
contains all of the menu fields.
Note that actual hard drive label shown may vary.
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
F9
Select
Sub-Menu
F10
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM if a
CD-ROM drive is installed at this connection. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and
Sectors for the drive.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
Setup Defaults
Save and Exit