Fujitsu Lifebook LH530 Manuel d'instruction - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Fujitsu Lifebook LH530. Fujitsu Lifebook LH530 34 pages. Lifebook ah530 notebook
Également pour Fujitsu Lifebook LH530 : Fiche technique (2 pages), Manuel Bios (16 pages), Pour commencer (13 pages)
Imprimer la page
Problem
PC Card Problems
A card inserted in
The card is not properly
the PC Card slot
installed.
does not work or
The card may have
is locking up the
been installed while an
system.
application was running,
so your notebook is not
aware of its installation.
Your software may not
have the correct software
driver active.
You may have the wrong
I/O address selected for
the activated PC Card.
Your PC Card device
and another device are
assigned the same I/O
address.
Power Failures
You turn on your
The installed primary
LifeBook note-
battery is completely
book and nothing
discharged, there is no
seems to happen.
optional second battery
installed or there is no
Power adapter (AC
adapter) installed.
The primary battery is
installed but is faulty.
The battery or batteries
are low.
The power adapter (AC
adapter) is not plugged
in properly.
20
Possible Cause
Possible solution
Remove and re-install the card.
Close the application and restart your
notebook.
See your software documentation and activate
the correct driver.
See your PC Card documentation to
determine the required I/O address. Change
the settings in the BIOS.
Check all I/O addresses located within the
BIOS setup utility and any other installed
hardware or software to make sure there are
no duplications.
Check the Status Indicator Panel to determine
the presence and condition of the batteries.
Install a charged battery or a Power adapter.
Use the Status Indicator panel to verify the
presence and condition of the batteries. If
a battery is indicating a short, remove that
battery and operate from another power
source or replace that battery.
Check the Status Indicator Panel to determine
the presence and condition of the batteries.
Use a Power adapter to operate until a battery
is charged or install a charged battery.
Verify that your adapter is connected correctly.