Fujitsu LifeBook S7110D Manuel de l'utilisateur - Page 27

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Fujitsu LifeBook S7110D. Fujitsu LifeBook S7110D 43 pages.

Imprimer la page

S7020.book Page 18 Friday, May 13, 2005 3:49 PM

L i f e B o o k S 7 0 0 0 N o t e b o o k

Flexible Bay Devices

Your Fujitsu LifeBook notebook contains a Flexible Bay.

The Flexible Bay can house an optical drive, a Lithium

ion battery, or a weight saver. (Figure 2-17)

Your Flexible Bay will have one of the following devices

installed.

Modular Dual-Layer Multi-Format DVD Writer: This

■

allows you to access movies, software, and audio

DVD/CDs and record to DVD, CD, and DVD-RAM

discs.

Modular DVD/CD-RW combo drive: This allows you

■

to access movies, software, and audio DVD/CDs as

well as to write to CDs.

Modular DVD-ROM drive: This allows you to access

■

software, data, or audio DVDs and CDs.

■

Modular Lithium ion battery: This is a rechargeable

battery that can be used to power your LifeBook note-

book when an adapter is not connected.

Weight Saver: This is used to fill the bay when no

■

device is needed.

REMOVING AND INSTALLING

MODULAR DEVICES

There are two ways to remove and install modular

devices in the Flexible Bay:

Cold-swapping: swapping devices while your LifeBook

■

notebook is powered off.

Hot-swapping: swapping devices while your system is

■

active using the Unplug/Eject icon from your taskbar.

Note that if the weight saver is installed rather than a

modular device, it is not necessary to use BayManager

when removing it

You should never leave your Flexible Bay

empty when the notebook is in operation.

If left empty, dust or foreign matter may

accumulate inside the notebook.

Figure 2-17 Flexible Bay

Cold-swapping

To cold-swap modular devices in your Flexible Bay

follow these easy steps: (Figure 2-18)

1. Close any open files.

2. Shut down your LifeBook notebook.

3. Pull out the Flexible Bay eject lever. This will push

your device out slightly, allowing you to remove the

device.

4. Slide your device out until it is clear of the bay.

This will require light force.

Figure 2-18 Removing/Installing a device in the Flexible Bay

Be careful when aligning and seating

devices in the bay. If the fit is incorrect,

you may damage the bay or the device. If

the device does not move easily in the bay,

remove it, and check for dirt or foreign

objects. It will require a firm push to latch

the device in place.

Flexible Bay Eject Lever

Flexible bay