AEG L 98499 FL Manuel de l'utilisateur - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG L 98499 FL. AEG L 98499 FL 44 pages. Aeg washer user manual
Également pour AEG L 98499 FL : Manuel de l'utilisateur (40 pages)

Imprimer la page

1. Troubleshooting

Problem

The appliance fills

with water and

drain immediate-

ly.

The washing re-

sults are not satis-

factory.

The internal lamp

is off.

After a steam

programme, gar-

ments are partial-

ly wet.

After a steam

programme, gar-

ments are not suf-

ficiently smooth.

The drum is emp-

ty and the display

shows there is

some weight in .

The drum is full

but the display

shows 0.0 kg.

After the check, activate the appliance.

The programme continues from the

point of interruption.

If the problem occurs again, contact the

service centre.

Possible cause

You did not remove the

packaging and/or the

transit bolts.

The load is very small.

The end of the drain

hose is too low.

The detergent you used

was not sufficient or cor-

rect.

You did not remove the

stubborn stains before

you wash the laundry.

You set a not correct

temperature.

Too much laundry load.

The lamp is burned.

The appliance is not ac-

curately levelled.

A wrong STEAM pro-

gramme has been selec-

ted (e.g. Synthetic in-

stead of Cotton).

Excessive laundry load.

It is necessary to set a

tare.

You loaded the laundry

before to activate the

appliance.

Possible solution

Remove the packaging and/or

the transit bolts. Refer to 'Instal-

lation'.

Add more laundry in the drum.

Make sure that the drain hose is

in the correct position.

Increase the detergent quantity

or use a different one.

Use special products to remove

the stubborn stains.

Make sure that you set the cor-

rect temperature.

Decrease the laundry load.

To replace the lamp, contact the

service centre.

Check the levelling and adjust

the appliance by raising or lower-

ing the feet.

Note the composition of the fab-

ric.

Reduce the laundry load

Press button

the appliance and to activate it

again.

Press button

the appliance . Empty the drum

and obey to the necessary steps.

(Refer to 'Loading the laundy')

If the display shows other alarm mes-

sage, contact the service centre.

ENGLISH

to deactivate