AEG L6FBI847 Manuel de l'utilisateur - Page 30

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG L6FBI847. AEG L6FBI847 40 pages.

Imprimer la page

www.aeg.com

14.10 Cleaning the inlet hose

and the valve filter

It is recommended to clean both the

filters of the inlet hose and valve

occasionally to remove any deposit,

collected over the time:

1. Remove the inlet hose from the tap

and clean the filter.

2. Remove the inlet hose from the

appliance by loosening the ring nut.

3. Clean the valve filter on the back of

the appliance with a toothbrush.

4. When you reconnect the hose to the

back of the appliance, turn it left or

right (not in vertical position)

depending on the position of your

water tap.

20°

14.11 Emergency drain

If the appliance cannot drain the water,

carry out the same procedure, described

in 'Cleaning the drain pump' paragraph. If

necessary, clean the pump.

14.12 Frost precautions

If the appliance is installed in an area

where the temperature can reach the

values around 0° C or drop below,

remove the remaining water from the

inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in

a container and let the water flow out

of the hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty,

install the inlet hose again.

WARNING!

Make sure that the

temperature is higher than

0 °C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

45°