Brother TJ-4620TN Manuel de configuration - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Brother TJ-4620TN. Brother TJ-4620TN 4 pages. Label peeler module
Imprimer la page
C. Install the Media Guide Bar and Rear Label Module
1. Remove the Screw on the back of the PCB Cover.
2. Remove the PCB Cover by pushing it toward the back of the printer, and then
lifting it with both hands.
3. Use a screwdriver to push the black rubber cap out of the opening in the PCB
side as illustrated.
4. Install the Media Guide Bar and Rear Label Guide Module and use a 13 mm
spanner or a 1/2 inch wrench to fasten it.
5. Reattach the PCB Cover (fastened by 0.49 N • m ± 0.07 N • m).
6. Complete the installation of the Media Guide Bar and Rear Label Guide
Module by loading the print media.
For more information about loading the media after installing the Label Peeler
Module, see sections 3.2 Load the Ribbon and 3.4.3 Load Media in Peeler
Mode (Optional) in your label printer's User's Guide.